Our Effect-Colour Sebapuff

Sebapuff 115 is a waterbased textile printing ink which will produce soft 3D effects with a suede hand feel. Result is a print with a relief-structured optics. It has a matte and soft surface finish. Because of its foaming texture Sebapuff is suitable for printing on light materials as well as it is for printing on dark materials. Free from phthalates, PVC, APEO and formaldehyde it fulfils the most exigent requirements of the Oeko- Tex- standard Class 1.

Special properties

  • Suitable for Cotton and blend poly cotton blends
  • Soft handle
  • Good wash resistance
  • Very good surface resistance
  • Stable to high temperatures
  • Does not show any yellowing
  • Free from phthalates, PVC, APEO and formaldehyde
  • Fulfil the most exigent requirements of the Oeko- Tex- standard Class 1.

Print recommendation

Mesh 34-43

Dilution

The inks are ready to use

Drying and Foaming

The ink has to be printed flat and starts drying under normal room temperature conditions. The foaming process only works if you put heat on it with a temperature of 120°-150° for about 3 minutes. Using the “Crosslinker 106” (add the drying time1%), is recommended to reduce the drying time to 1,5 -2 minutes and also to improve the general fastness properties.

Emulsion

Emulsion for waterbased coloursystems is recommended

Cleaning

Water can be used, make sure you do it immediately after the printing process. Ammonia can be used also for cleaning (water ­+ 5 %), rinse with warm water after cleaning